Guess who's still around :icon_cheers:
I have a pile of parts I'm going to throw together and hope it works. Some will remember I lost my B2 over 2 years ago in a garage fire. Been collecting and sitting on parts for my next rig.
97 2wd Ranger frame
94 Explorer 4.0, A4LD/5R55E...
Picked this up for $400. Was planning to build my own, but the cost of 2 axles would have run me close to what I got this for.
Its 14x7, 2 6 lug axles with electric brakes.
After looking at it, the guy needed to clear all his stuff off.
Got it home. Also had a full width 8.8 in the bed of...
My tach does not respond. It moves as the rpms go up, but its not correct. I already tried to swap it for another unit. Where does the tach get its signal from on a motor with a coil pack?
Also swapped in 3.73s. Currently have a black 20 tooth gear. What gear should I be looking for to correct...
So I picked up a 91 Ranger XLT on Sunday. 2.3, 5 speed, 2wd, single cab, long bed.
No huge plans for it at the moment other than a drop, but then we all know how the B2 build went as well.
Pic from CL ad
Sunday after picking it up.
And one next to the B2.
Monday I installed the 2002...
Ok so we picked up a 96 Explorer control trac 4wd with I believe a 4r55e. Did a full tune up which included tranny filter and fluid. Not a flush.
Now transmissions are not my strong point. I've swapped manuals and replaced several clutches, but anything internal I have not messed with. Add the...
So I was doing a little research and it seems I need certain Chevy or Jeep knuckles for high steer. The 2 sites I found said there is no enoungh room on Ford knuckles to mount the brackets. And based on the pictures they provided, I believe them. The problem is my knuckles don't look like the...