Hello all, I'm wondering what ujoiny I need to use to make a 1 price aluminum driveshaft to a 9" out of a 76 eb
The moog part number for the u joint I found for the 9" is #280 and the aluminum is #270, both moog p/n.
Now the reason I'm doing this is because every time I put a new u joint in my...
Anyone know how I should go about determining what size shocks I should get for my SAS swap? I have no idea how big my coils are supposed to be. As of right now I can barely fit my 38.5s (I'm going to cut my fenders as its a mud) but I'm having trouble figureING out what size shocks I need...
93 2wd ranger 4.0 5 speed
Eb d44 and 9 inch
Got a 4wd trans and tcase from a parts rsnger
Got the rear end all bolted up with 6400 shackles and got the front end sitting on the ground with radius arms bolted up and coils sitting in the buckets..
Mocking up the tracks bar mount tomorrow and...
I have a eb d44 I am planning on swapping into my 2wd ranger, now couple of urgent questions seeing as I'll be starting the swap next weekend
1) I read somewhere if you use stock coil buckets with eb loft coils it increases the lift by around 2-3"s? Is this correct?
2) I have the "Y" style...
I'm swapping a 4x4 trans/t-case into my 2wd ranger that is getting a SAS swap, my question is the t-case is electric. So I was wondering if anyone has wired up a 3 way switch or something to do 4h, 4lo, and 2wd or if I need the pcm and all wires from 4x4 ranger to hook up the factory switch. Any...
I'm starting my swap and I found that the steering linkage is the y setup.
And I'm not sure how much lift the coils are I got from the donor rig, and also will the stock ranger pitman arm work?
So questions in a list.
1) will a Rangers stock pitman arm bolt up to 77 eb drag link
2) my coils have...
Does anyone know of the Explorer 5.0 will bolt up to the 4.0 the speed or a 60s c4 Auto?
Or should I take transmission and t-case from explorer too?
Also this is going into a 93 ranger with eb Dana 44 front