• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Search results

  1. RaceRanger97

    Raceranger's 4x4 Build

    Welp she survived KOH! This thing creeps through the big rocks really well now. Can’t believe the only body damage I got was a tail light. Very first thing I did with it was pull it off the trailer and go up chocolate thunder which was a little intimidating and stressful learning how to use the...
  2. RaceRanger97

    Raceranger's 4x4 Build

    I love it. Hope I don’t ruin it at KOH
  3. RaceRanger97

    Raceranger's 4x4 Build

    Well it’s all in there! Trans is acting up a bit so hopefully that’s an easy fix. Low Low is sooo Low.
  4. RaceRanger97

    Raceranger's 4x4 Build

    Finally got rid of the scratched up purple tint. Couldn’t even see out the back window.
  5. RaceRanger97

    Raceranger's 4x4 Build

    Come on by! I’m pretty much always at the shop.
  6. RaceRanger97

    Raceranger's 4x4 Build

    Ignore the mockup hardware, but the case got some protection.
  7. RaceRanger97

    Raceranger's 4x4 Build

    Ya definitely need stout radius arm mounts on go fast trucks. I've seen all kinds of stuff bend/crack in the desert.
  8. RaceRanger97

    Raceranger's 4x4 Build

    yeah, they will hold the weight of the drivetrain fine, but probably won’t take a hit very well. That’s why I wanna have a belly pan under all of it.
  9. RaceRanger97

    Raceranger's 4x4 Build

    Pulled an all nighter with Max from Built Industries, got both x members done and the hard part of the exhaust. The plan is to build this kid plate/belly pan below the T case. Ignore the mismatched rock lights lol.
  10. RaceRanger97

    Raceranger's 4x4 Build

    Hoping to have both Rangers at King Of The Hammer event Feb 5-8.
  11. RaceRanger97

    Raceranger's 4x4 Build

    Yes, should be helpful in the big rocks
  12. RaceRanger97

    Raceranger's 4x4 Build

    Took the Transmission in to swap the output shaft to match the Atlas. Trans ended up being toast according them which was a fun surprise. So it got a full rebuild with some updated parts. Got it all mated up and in. Gotta build x members and drivelines next.
  13. RaceRanger97

    Raceranger's 4x4 Build

    Motor mounts were toast, replaced them while everything was apart.
  14. RaceRanger97

    Raceranger's 4x4 Build

    Collecting parts to completely redo the exhaust. Hopefully it sounds better this go around.
  15. RaceRanger97

    Raceranger's 4x4 Build

    This thing is not going to fit without a fight. Also learned that this thing did not have a Bronco/F150 4x4 AOD like I was hoping. It has a 2wd AOD (likely from the Mustang the motor is from) with an adapter to the Ranger 1350. So now I have to pull the transmission out and replace the tail...
  16. RaceRanger97

    RaceRangers Build

    Finally tested out the new clutch. Good to go.
  17. RaceRanger97

    Raceranger's 4x4 Build

    Pretty dang excited about this. 2.72:1 / 3.8:1 / 10.34:1

Sponsored Ad


Sponsored Ad

Top