Ok...old post of mine but here we go. Been wanting to swap gears. Went with 4:56 with 31” General ATX tires. I also have a full set of 32” Mastercraft MXT’s mud terrains. Did the swap during the Covid plandemic. Gotta say I am super pleased and should have done it long ago. I don’t do much hwy...
Just checked the tire/gear ratio chart on this site and decided on 4.56 instead. I putt along anyway so why not have the power and lower gearing while off road. I am blown away that I haven’t roasted the old stock clutch in the 7 yrs I have owned this truck.
The only section of hwy I have is 70 mph but I rarely use it. If I do it is for about 20 minutes. Two lane paved roads mostly. I think I will do the 4:10s. I have lived with 3:27s since 2013 and made it work so 4:10s should be awesome.
94’ 4.0 manual 4x4 w 2” lift. I haul a 65 gallon water tank and gear for my business. I just bought a 4x8’ trailer for hauling a larger water tank 125 -300 gallons. Trailer has a 3500 lb axle with brakes. Current gearing is a horrible 3:27 but have not blown the stock clutch yet. I off road a...
94’ shortbed single cab. Need new tank. Anyone know of a good place to buy? Also, might be a good time to install a rear transfer tank since I have removed the spare tire under the bed. Anyone do this? What is involved and was the end result worth it? Thanks!
I have a 2” lift on my 94 4x4 4.0. I just have the spring spacer up front and rear extended shackles. The front is still quite nose down. I want to lower the rear some but I cannot use the other holes on the shackles due to the rear trailer hitch. Can I remove the stock lift blocks and add a...
94 F150 w 5.0 engine. Went to start it and no sounds or lights at all. Complete silence!! Battery and all connections are good. Guessing something electrical huh?
Anyone know of a good complete kit for a 94 4x4 w TTB. Also need U joints since the ones I have are from factory circa 94’. Also anything else I might need to get the old girl tight ?.
94 w warn front hubs. Changed tires today and noticed that both hubs will wiggle if U push the top and bottom of the tire alternately. Side to side seems fine. I have had new ball joints on both sides done this summer. The hubs are about 2-3 yrs old. Why the wiggle?
Used this before but decided to try it in my OHV 4.0 ranger the other day when I did my oil change. WOW, quieted the engine down quite a bit. It always had a slight tapping sound which they are known for, gone now! Thought I would share.
I do live in PA but thank God I don't live anywhere near Philly this week! The smell of progressive hippies makes me ill! BTW, why do they call themselves the "Democratic" party now? Havent' they been the "Democrat" party up until recently? Nothing "democratic" about them, just ask the Bern...
Mastercraft Courser MXT's on my 94' lifted 2". $162 each total, put on and balanced, cheaper than Cooper STT Pro's & made by Cooper.
U can see the 2" aluminum spring spacer in this pic.
Side view, left the blue stuff on sidewalls cuz it matched my paint lol.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.