Yes B75 I had two sets, a cheap brand I got in offer up for $20 bucks and the factory ones. Tested both and measure resistance. Ended reinstalling the factory ones. For a truck that had three bad cylinders the truck ran well except for the rough idle. So I did not think the injectors were bad...
short update, damn truck nothing makes it run better. Still p1152, p0171, p0175. Lean on bank1 rich on bank 2. I am actually thinking about looking at the old motor to see if the rings were not installed correctly. It looks like it was recently rebuilt.
I did install a ford O2 and a Bosch O2...
Yeah, they rarely go bad but I have seen that in Nissan vehicles and on Hondas. I did a visual inspection saw nothing unusual. Truck is close to 200K.
I did not inspect the valve seats. Knowing what I know now I should have disassemble the head totally. I know for a fact that the RHS is prone to...
That is a good point I have not looked into it. Compression in #2 is lower than the rest I have seen a utube video where I guy found the problem you are describing. I may have to try a leak test. But the motor has compression, except for #2 which gave 120 but the battery was a little low. I had...
This is not a flex truck. I don't think it has a module I was looking around the tank area did not see one. It is a 2002. It has a PATS built into the PCM.
Low oil fuel pressure is easy to spot the valve train will rattle badly. I have seen that in a mustang before due to the fact that the valve...
I will check the LHS head once I try to put the injectors back. I have not inspected this head, it does seem a little noiser than the other side. I did the head gasket on the other side. I also have a set of new injector connectors to fix the broken ones a repair is necessary. Thanks
I actually drove the truck from L. Havasu to Phoenix running on 3 cylinders. It ran decent except had no power especially going up hill, vibrating at idle. Thus gas was not an issue. That is why I thought after changing the motor truck should have been running w/o any mayor hick ups. It ran...
for any one interested I just replace the PCM truck had a minor improvement. Thus far codes are: p1152 & p0175. Now both codes are related. I have to keep looking for a solution. If anyone has found one for either code let me know. Otherwise as usual I am on my own. Will never buy a ford.
This problem seems to be like mine. I am waiting to get a re-flashed computer. I have better compression. Also I discovered today the previous owner had installed 3 different tires sizes 225/75/15 at the front, 215/75/15 rear driver side and 225/70/15 rear passenger side. I recall seeing p505 in...
Hi I am new to this list and in desperation I decided to post my problem.
A friend bought this truck with a bad motor. I replaced the motor after that the truck ran decent for 1 day and since then it runs rough and lack acceleration. Here is what I have done:
- replaced coil pack, plugs and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.