• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Search results

  1. Steering Shaft Boot

    Sounds good, build looks good btw
  2. Steering Shaft Boot

    How's the boot holding up, I did the same thing little less than a year ago and the boots pretty much shot from the areas I zip tied. Also does anyone on here have a ranger that makes like a grinding sound when the turn for me it's more at low speeds and when I turn the wheel to the left. Could...
  3. 33" on a 2000 4 x 4 Ranger

    I measured the block and it was 2.5" and on it along with other part numbers it said "4x4". So, Just to avoid any issues I think I might stick to a 31x10.50r15 bfgoodrich all terrain tire. Laterrrrrrr on down the road upgrade to an 8.8 4.10 rear end. Sticking to the 31's what issues will run...
  4. 33" on a 2000 4 x 4 Ranger

    This is a 2wd ranger that i am lifting, so no torsion bars
  5. 33" on a 2000 4 x 4 Ranger

    I have a a 2000 ranger with a 2.5 inch oem lift in the rear with the I think 4x4 leafs (it has 4 leafs instead of 3) with a 2 inch lift kit up front. What's the biggest tire i can put with out rubbing at all? 31s, 32s, 33s?
  6. Complete OEM Cruise Control Installation

    I'm asking because the non clicky ones that did not light up seemed to be more realistic/ authentic than the "oem" ones. And the oem ones feel fake. Unless someone swapped them out and I got screwed over
  7. Complete OEM Cruise Control Installation

    Curious question about the buttons. I installed cruise control on my truck (everything works fine). But I was curious how the oem cruise control buttons feel. I ordered some off Amazon. The buttons were not clicky at all and had no back lit on it. So returned them be ause i want them to light...
  8. Learning the hard way- Cruise Control buttons

    Curious question about the buttons. I installed cruise control on my truck (everything works fine). But I was curious how the oem cruise control buttons feel. I ordered some off Amazon. The buttons were not clicky at all but had not back lit on it. So I ordered the "oem" ones (motocraft) from...
  9. any measurements for fender flare holes

    Im bringing this thread back because I'd like to add the rear fender flares to my current bed that does not have any. Please anything helps, a template or if there's another thread elsewhere
  10. Complete OEM Cruise Control Installation

    Say everything goes well with the install. Would my guage clusters "cruise crontrol light" light up or qouod i have to install a bulb in the back of the cluster? Curious on how that would work
  11. Complete OEM Cruise Control Installation

    This is my current clock spring, I only have 3 wires coming out from it. I ordered a newer clockspring from ebay with the part number "1998-2005 F87B-14A664-CC OEM" the newer clockspring has 6 incoming and outgoing wires. Please tell me I'm prewired and just need the clockspring to complete...
  12. Complete OEM Cruise Control Installation

    I have 2000 ford ranger xlt that didn't have cruise control. I am adding cruise control to the truck and have all necessary prerequisites to be considered "prewired" i hope. I'm am a little iffy about the brown connector that connects to the clock spring. I have 6 incoming wires but I have 2...

Sponsored Ad


Sponsored Ad

Top