• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Search results

  1. n_bannerman

    Major bump steer with leaf spring sas, help

    Not sure if this should be in here or steering but I am having major bump steer with a leaf spring sas. Running a rear shackle setup with rancho 44044 spring set up spring under for a few months and have been fighting to get rid of the bump steer. Also when I corner hard it feels as if the whole...
  2. n_bannerman

    Trouble removing radius arms from d35

    Having trouble getting radius arms off of a d35 I just picked up. I've used 5 foot breaker bar with hitting the bolt with a sledge hoping that would work and also hit it time and time again with a battery powered impact. The bolts have been soaking in lots of pb blast for the last 2 days and...
  3. n_bannerman

    goodyear duratrac

    got them from a new tire shop out at state line, Blue Mtn Tire Pro's. a buddy works there and said that they price match if you pay cash and its tax free being oregon. snow wheeling sure is a lot of fun, supposed to get close to a foot in the next 24hrs on tollgate!
  4. n_bannerman

    anyone run a welded 7.5 for dd use?

    I got my hands on a free carrier and have been thinking about welding it up. does anyone run a welded 7.5 for dd use and how do the rear shafts take the abuse? sick of doing one wheel spins front and rear when ever im in the mountains so its time to do something for the rear and this would be...
  5. n_bannerman

    goodyear duratrac

    Got them for $864 out the door from a local tire shop mounted and balanced.
  6. n_bannerman

    goodyear duratrac

    Forgot to mention that I was getting 21mpg with them and stock 3.73 gears. What air pressure is everyone running, the dealer set them at 30 but I'm thinking it should be more like 25 from the contact patch I have
  7. n_bannerman

    goodyear duratrac

    I finally picked up a set of 33x12.5r15's yesterday. Man do these drive nice! Immediately hopped on the road to clarkston after getting them and on the pavement they handle really well with just a slight hum, not as bad as a mud tire but more then the trashed at's I've ran. I also found that...
  8. n_bannerman

    Help! Removing rear blocks and have an issue!!!

    Half way point of removing the block on the rear of my truck and my u-bolts are not threaded down far enough, can I drill a larger hole in the block and run it ontop the spring pack till I can get new u-bolts? Thanks!!!! Nathan
  9. n_bannerman

    Egr delete?

    What would I need to do to delete the egr and keep my 2.3 running right? I have had 2 go out on me in 2 years.
  10. n_bannerman

    Kingpin d60

    What model and year?
  11. n_bannerman

    Kingpin d60

    What would should I look under to find one?
  12. n_bannerman

    Irok or rockers for snow?

    Looking at both the 35x14.5 15 rockers and 36x13.5 15 iroks on 10" DIY bead locks, what would be a better snow tire? I know I can fit 35's but know I would have to do some more to fit the 36's.
  13. n_bannerman

    2.3 fuel pump not working

    Have an 86 2.3 that lost power to the fuel pump or the pump died. Trying to find the fuse for the pump but can't find it, where would it be hiding? Also I replaced both pumps and filters this summer.
  14. n_bannerman

    Clutch leeks when temps is below 32 degrees.

    So been fighting a issue with my clutch when it gets cold out side. Will work perfect at 35f but below 32 I loose pressure and can't find the leak anywhere. Any ideas what to check other then keep adding fluid?
  15. n_bannerman

    Leaf slung d30, what model and year of jeep should I look at?

    The reason I was looking at doing it with leafs is $. I know an sas ain't cheap but I'm tired of fighting the d28 to get rid of the bump steer and to work properly. Around here, we mainly have toys with leaf sas's and they ride nice. I'll look into the link set up though. Also I've been running...
  16. n_bannerman

    Leaf slung d30, what model and year of jeep should I look at?

    I'm also not going for tons of flex, I'm trying to keep it under 4" of lift if I can.
  17. n_bannerman

    Leaf slung d30, what model and year of jeep should I look at?

    It's easy and simple. Other then the shock mounts and spring pads it's almost bolt on.
  18. n_bannerman

    Leaf slung d30, what model and year of jeep should I look at?

    I know everyone says d30 are crap but all I will be doing is snow wheeling and dding it. What year jeep and model should I be looking at?
  19. n_bannerman

    Recommendations for a reasonably priced impact socket set, 3/8 and 1/2"?

    The sales men said both are rated at 600ft pounds and my gun is only at 200ft pounds
  20. n_bannerman

    Recommendations for a reasonably priced impact socket set, 3/8 and 1/2"?

    Well I'm saving up for snap on now due to wrecking a brand new 1/2-3/8" impact adapter and cracking a 29mm deep impact socket from crapsmen while replacing radius arm bushings just got both tools yesterday and broke today on a light job.

Sponsored Ad


Sponsored Ad

Top