Search results

Loosen the retainer bolt. Back it out 3/4” , using a puller, screw two bolts into the harmonic balancer, place the center bolt against the harmonic balancer retainer bolt that you have left backed out 3/4”. Tighten the puller center bolt. You balancer will slide right off. You can buy a...

So loosen the center bolt out 3/4 of an inch? Put the center bolt of the pier against it , then pull? Use heat if needed

Thank you. I encountered this issue tonight. I was using a claw type puller

Rebuilding the original 2.9 in Arizona , now that it is no longer 112 degrees out. Then off to a new coat of paint.

I purchased the ohv engine. Probably a mistake? What do you think? I could go out and find an sohc.

Thank you. I purchased the guides

Have a 4.0 and 5r55 from a 4 WD explorer (‘98) any suggestions before I start? I do not have the key from the explorer. Have everything else, except the dash and pedals

Considering adding a Trans fluid Temperature gauge to my 86 4 x 4 auto trans Ranger. Has anyone else had experience with them? I looked on Amazon,,saw several different styles. Seeking advice

I own two Rangers an 86 4x4 for fishing and shooting trips. Also, a 97 work truck for daily use in my contracting business. I've been a member for 5 years. Just don't log on much.

anyone know where I can get an intake manifold bolt kit for a 3.0? Rebuilding the top end and mine are pretty cruddy. Looked all over the Internet to no avail. Thanks.

had a valve seat drop on my 97 3.0. Left a little impression in the piston. I can just barely feel the indent with my finger nail. Engine turn over fine with no issue. Sanded it a bit. But the cut is still there. Do I need to worry about this? Anyone else with the same problem or issue? Have...

just finished complete AC rebuild on my 97. Now going to change my 86 over too. I can't find the high and low side connectors like on the 97. Where are they? I used the Enviro Safe R12 R134A replacement. Works great my AC is 42 on these hot 110 degree Arizona days. On the 97 I replaced every...

I was thinking it would be a great project to build up a smaller scale Airstream style trailer . I know it wouldn't be cheap. but a fun project

My idle keeps bouncing between 900 and 800 rpm. Dose it every 2 seconds. Now and then it will fall to 500 rpm and die. I have searched everywhere for a vacuum leak. No codes. checked everything. Put a hose clamp on the pvc to manifold vacuum line. It was working perfect staying right at 850 rpm...

I have an 1986 ranger STX 4 x 4 with an auto trans, 2.9 . My computer has failed,I need to purchase a new one. The one in my truck says REMAN on it. The part number indicates it is from a different truck. The guy I bought the truck from shopped at junk yards. The truck ran poorly. I can not find...

86 Ranger 2.9 , My in-tank fuel pump only runs if I jump the green fuel relay. I have changed the relay, the ignition switch, jumped the inertia switch, Checked every fuse and inline. Grounds seem to be good everywhere too. I have a code 87 (primary fuel pump failure) code. There is no +12 power...

Just pulled the tag off my 86 ranger 4x4, the nubmers on it are as follows, 389c, SL10 A756E16 . I can't find info on them, can anyone help? thank you