Search results

Can anybody help me with this problem?

I have a 1996 Ranger Splash 4.0L V6. I just put a new alternator in the truck but I have an extra yellow and white wire that comes from or to the junction box that, I assume goes to the under the hood fuse box or from/or to the PCM. I don't know where it goes but I don't think the alternator is...

I need a diagram for a 96 splash power windows

thank you for the help. I'll let you know how it goes.

I will try your suggestions. I be back on here later to let you know how it went. I thank you very much for the help.

Ok, thank you very much. I'm gonna go try this out . I'll get back on here and have a report when I'm done.

Yea, I am gonna pull the piston out of it tomorrow and bleed that. I hope. So you have any advice for that? I don't know how to do that without losing any insides from the master cylinder.

I have never had this issue before. this is the 2nd slave cylinder I have installed. Both brand new

it starts to get a peddle but then its back to square one.

Yes, the slave cylinder is new. actually everything that has to do with the clutch is brand new all the way back to the resavoir. It just wont bleed out the air.

yes i changed the slave cylinder pressure plate, clutch, master cylinder hydrolic lines and resavoir. I replaced everything. I think it has the 55 tranny in it.

The slave cylinder is inside the transmission

I have a 1996 ranger splash. I have brand new clutch, slave cylinder pressure plate, master cylinder, resavoir and hydrolic lines and I cant get the clutch to pump up. anybody got any suggestions?

ok. The hydraulic line isn´t kinked. I dropped the transmission again and I´m about to put it back in and hope for the best. I´ll keep you posted. Oh, now i seem to have trouble getting the tranny to line up and meet the top of the motor. I´ve got the bottom bolts in but it doesn´t line up at...

oh and does my clutch plate need to be adjusted since I put a new clutch in it?

Well it´s been raining here for the past few days, so I´m not really sure if it is or not. The last time I was under the truck it looked like it could be. I´ll check it out tomorrow for sure. Cam you think of anything else I should check? I´ll let you know if it is or is not kinked. It has a...

1996 Ranger Splash 4.0 has a clutch problem. i recently took out the transmission and motor. I put it back in with a new clutch and now my clutch peddle is hard to press. Could it be binding in the motor or could it be the clutch plate needs adjustment or not getting enough hydrolic fluid?

I was wondering if anybody has a diagram for under the dash on a 96 ford ranger splash. It was an automatic but I put a 5 speed manual tanny in it from a 98 xl ranger base model. ( meaning the 98 didn't have electric windows, power doors, etc.....) I'm thinking something didn't get plugged up or...

I swapped a 1996 4.0L V6 to a 1998 4.0L V6. The 96 had an automatic tranny in it and the 98 had a manual tranny in it. My speedometer and tempeture gage doesn't work. How do I fix this problem and should I install another speedometer gauge?

I have wiring issues and I'm lost.