-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Search results
-
Simple Seat Swap
Yep just removed the wire mesh and ground off all the clips on front side to get two smooth mounting surfaces. Also used couple pieces of 1/8” plate to bridge those small gaps seen on the back side where the marks are on the inside of both sections of the 60/40.- HappyClouds
- Post #3
- Forum: Seats, Carpets, Consoles, And Interior
-
Simple Seat Swap
Quick little budget friendly seat swap on a 93. Seats from 2011 ranger, center console from a 95 F150. 0 -> 3 cup holders :) Mate the new seat frame to the old bench slider, couple welds, and cut a hole for the cup holder, done.- HappyClouds
- Thread
- Replies: 2
- Forum: Seats, Carpets, Consoles, And Interior