I own a 2nd Gen (92) Ranger w/ 5 speed m5od transmission. My question is have any of you out there installed a shift boot and trim similar to the ones found in the 96-97's with the built in cupholders into a 2nd Gen truck? Any advice on the level of dificulty and pics would be greatly appreciated.
added
After roughly a month I guess I'll ressurect this thread. Thought this was a neat idea and it was really interesting to see where all my fellow forum members are located so I added myself.
storage idea
A large plastic cooler should help keep things dry. Place in the rear where you want it then weld or bolt on some D-rings to the floor so that ratchet straps can be used to secure it in place wile not in use. May not be too pretty but its fuctional and economical.
Just curious to see if any of the members have tried their own ballistics testing with pistol calibers and the methods used. I know about the wet pack and gel type tests. Just curious to see if there were other methods out there that might more closely mimic a self defense type situaion. I have...
Gun Broker
I have not used gun broker to buy or sell. I can however tell you that firearms transfers between individuals do NOT have to be completed by an FFL dealer if you meet face to face. That being said the person buying your firearm may lie about their ability to legally own a firearm. Do...
Have a 92 2.3 2wd with a tired front end. Does anyone know of a complete kit, one that contains all the front bushings. This would seem a much easier route than trying to source all the diferent bushings individually from the local autoparts stores.( I have had a few bad experiences with...
Anyone with a cracked EGR tube on their Gen2 with a 2.3 knows what a PITA it can be to find a replacement so here is my solution.
1. Locate break/crack/hole in tube
2. With a hand held hacksaw or reciprocating saw cut tube in center of break
3. Remove EGR tube at EGR valve
4. Slide a length of...
Have a 92 single cab with the two piece sliding rear window... would like to switch to a later model single slide rear. Anyone know if its possible w/o cutting the back of the cab
I have a 92 ranger with 2.3 and manual trans. Anyone have experience with the JET Performance computer modules that are available for these little 4 bangers? ( specifically the JET 89202). Interested in any noticeable gains and or negatives you might have experienced. Thanks.
I have a 92 with a 2.3 and 5 speed. Firewall is separating near my clutch master cylinder. I've been told this was a common problem on the RBV's and that you can find a bolt on support that's made specifically for this. Currently have a piece of lumber (southern engineering) keeping the firewall...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.