Search results

Thanks. I was stabbing in the dark lol!

Fwiw, I've noticed that during fall and the day they call winter, the truck is peppier than during the heat of the Florida summer.

Ik this is old but, how's that VB doing? I'm looking at Central Valve body too. Thx!

Don't know how to delete.

Sorry been away for a while. So, I think I know what it is now. Last November had the evap core change. Haven't really looked at this area since I installed thermo housing. Noticed this thing while doing tune up. Now, I've got to replace my ac system again! Prior to the evap job, I had them...

Thanks for the reply. I'll look at the TB cover but I don't recall seeing anything but three screw holes to mount it. I'll inspect the area and the air intake hose.

Thanks for the reply. It wasn't there a few months ago when I replaced my thermostat housing. So far I can't tell any difference in the running. Perhaps it's a cover for a screw or something.

Hello everyone. I was inspecting my engine bay and found this rubber plug on top of the engine, near the thermostat housing where the heater hose 90s down. I looked on the intake and couldn't find a hole this size and afaik there's no drivability issues or codes. Any help identifying this is...

Thanks for the reply. I replaced the hoses with Motorcraft hoses for both heater bypass, upper and lower. I read the post about getting the bigger o-rings for the sensors as well as using the original clips. I tracked the leak down to the sealant that holds the upper bypass nipple into the...

Thanks. Forgot to include, this is with the aluminum housing. After my second plastic housing failure I luckily found this thread to guide me

I know this is old but, has anyone had a difficult time getting hoses to seal at the heater bypass nub of the housing? Mine seeps no matter what clamp or position.

Hi from sunny Florida! I purchased my 2009 Ranger with 148,000mi on it from the State. I've had it 6 years and it now has 238,450mi. I'm going to try to take her to a million!