Search results

I have a 1987 2.9L short block and oil pan and some miscellaneous parts taking up space in the garage , need it gone , hate to scrap it . I also have a 89 RWD 5 speed transmission in the shed that needs to go , flywheel and starter included , hate to scrap that too , it only has 60,000 on it ...

I have a 1987 2.9 shorblock with bad cam bearings you can have . Located i Connecticut.

Sounds like the trans. Crossmember may need to be relocated ?

Thanks . That is good info to know .

Ok . If anyone has one to part with please let me know . Thanks again.

I have a 87 Bronco II with a A4LD auto trans and 2.9L engibe I would love to swap in a 5 speed if or when the A4LD fails. I have found what looks like a FM145 out of a 87 Ranger 4x4 with a 4 cylinder. Would this be a compatible trans swap? Would i need a 2.9L bellhousing? Thanks

I may be selling my 87 BII . Its in great shape southern truck . 207,000 miles on truck. 1989 2.9L with 60,000 miles installed last spring. Auto trans was replaced at one time i just serviced it with full synthetic and a motocraft filter during engine swap. I am 3rd owner . I have service...

In my opinion the passenger side springs get more worked so wear a bit more. I have swapped them if i have them out.

I am looking to upgrade my 87 Bronco II Transmission crossmember to the later model type. I have had no luck finding a decent one up here in CT. Thanks

I purchased a Melling 328 oil pump for my 2.9. The box says 328 but the marking on the pump reads 128 ? Anyone else notice this ?

I would also stay with the factory type insulators . Advance Auto has them.

My extra spacer was only on the passenger side. My truck also had different alighnment bushings from the factory.

There is a good illustration on page 42 of the LMC truck Ford ranger online catalog.

My 87 Bronco II 4x4 had a large washer about 1/8" thick under the passenger side spring seat. I figured it was installed at the factory for alignment reasons. I lifted the truck and so i used adjustible bushings and left the washer out.

Im looking for at least one good auto locking hub for a 96 ranger. I am sure someone out there has one ! Thanks

Would a bad intake gasket leak antifreeze into the engine ?

Well looks like it may be the thermostat bypass hose or connection. I took a chance made a offer .

Didnt think of doing that . Thanks.

A friend of mine has a 98 5.0 with 130,000 . He says there is antifreeze spraying out somewhere on the passenger side front of the engine. He checked hoses. He thinks head gasket. My questions are how common is it for a 5.0 head gasket to blow antifreeze out in this location? Is the 98 Merc. 5.0...

My 87 Bronco II has the CV type driveshaft and i am planning a 8.8 swap so i am wondering if a 2006 1354 rear flange could be swapped into my 1350 transfer case.