Search results

Been thinking about a zoomie setup for my 2.3L.

So what if I wanted to do a back-half to a 93 ranger using a 98' & up rear frame section? Would the newer frame section slip over the older frame at the crossmember/front leaf spring mount area?

I don't suppose I could use the back half from a 98 ranger since it is modular could I?

Hehe, well it's been in the family since '94 so I'd like to keep it in one piece and not break myself or someone else, either.

Well, I think I'm gonna have to park the little green monster for a bit. I noticed rust holes in both of the forward leaf spring hangers in the cup above the spring eye and around the bolt. Also, on the passenger side, rust was pushing the base of the hanger away from the frame in between the...

Just want to get some feedback from those way more experienced at this stuff than me. I Started with the KOEO test and it immediately flashed 111, then reported codes 223 & 224. Started the KOER test and it flashed 998 & 224 but never flashed the engine ID code (2) to tell me when to turn the...

I use Seafoam. Has always worked well for me. You can even put a little bit in the oil just before an oil change.

Okay, so if I read that right you used two different products. Which one works?

Finally got back to it. For some reason Ford thought it necessary to use 5 bolts to hold the A/C-Power Steering Pump bracket on! Two of which are REALLY hard to spot.

Thanks for the insight guys. After I got the center bolt loose, the pully hub came right off. I used a pipe wrench (pics below) with the handle pinned against the steering linkage to hold the crank. Interesting observation, one of the four bolts for the hub line up with the keyway. It...

Any tips for getting this type of crank pully removed?

1993 2.3L they share the same mount.

Any tips for removing the A/C - Power Steering bracket from a '93 2.3L? I have three bolts out and can't see any more.

Thinking about converting 2.3l to manual steering. What will I need besides the box to make the change?

Whe the timing belt broke on my 93 2.3, I had to turn the wheel several times to get it turned around and pointed back to the house. Today, while lust looking around under the hood, I noticed several things were wet on the drivers side of the engine bay. There was a puddle of fluid in the...

I am trying to do the same thing.

Getting ready to change out a broken timing belt. It let go at about 30mph while decelerating to a stop. Should I be concerned about internal damage to pistons? Does anyone know the built in advance of the cam?

http://racerwalsh.com/product/holley-to-efi-adapter-1-2bbl-rwa1232a/

Thanks, 2Krngr. Had the alignment done and everything is in spec but it still pulls right a bit. I do have to replace the sway bar link on the passenger side but not sure if that will make a difference.