Search results

My youngest son has a 2001 F150 4x4 off-road he bought yesterday. It’s a decent truck…. It’s rusted out but for $1000 and it just recently got new brake lines, fuel lines, and brakes and no holes in the frame…. But it’s stuck in 4wd. I can’t see anything behind the transfer case skid plate…. How...

This is the regulator for my replacement Royal Enfield. It needs to be relocated to where it’s in an airstream so I am going to mount it to the bottom of the yoke over the front mud guard. what I need to know is if I can use thermal paste and a backing plate to cover up the back

It’s been 30 years since I took basic electronic principles but that’s what I did. Wired the headlights via relays directly to the battery. I have a toggle switch for the low beam relay and a floor switch for the highbeam relay. Eventually I want it to work off the factory switch.

If I’m blowing a 10a fuse every 4th time I use the switch on a circuit (18g wire, rated for 13a-15a) that’s only drawing 1.43ma… and removing the switch fixes the problem then my problem is this Jegs GM style floor mount highbeam switch right? next question. How do I use the stock headlight and...

Yeah I can’t find any not fake reviews on DIY Solutions. I got the shafts out and they are straight so I’m just going to replace the u-joints. Anybody ever use this tiger u-joint tool and the u-joint press? Because my vise with hardened impact sockets is not going to press these u-joints out…...

Replacing the front Axle shafts and wheel hubs on my 2500 Ram. The Detroit Axle stuff is $101 more than TRQ or DIY. I’ve never heard of DIY and I can’t find reviews. TRQ is like Russian roulette… sometimes you get a good part, sometimes you don’t… Detroit Axle is supposed to be the good stuff...

Not even a Ford. The problem with buying used Fords is that are in my price range are twice as beat as everything else. this is what I did with my insurance money from my Jeep 2004 Ram 2500 crew cab 4wd with a Hemi

Spark plugs are changed. We had to use a cheater bar on the back 3. So new coils, new spark plugs. Cleared the codes, did the relearn. Runs like new again. the rear 3 plugs were so bad I don’t think the dealership changed them at the 200,000 mile service. I think they only changed the front 3...

Well that adds a new level of difficulty

First off… I apologize for the Chevy questions on a Ford site but over the last 20 years I have learned that if I can’t find the answer (vehicle related) on this site then the answer doesn’t exist. Second… I appreciate you guys answering my questions. Third…. I hate going to that S10 forum...

There was no play in the socket on the other plugs.

I was warned against trying to decoke and engine with this many miles so I didn’t do it. I pulled the 3 plugs from the front of the engine. They need to be replaced. The spark plug in the photo is number 6 but that is what they all look like. moved the number 6 coil pack to number 4 and number...

I’m going to be back working on it tomorrow. It’s been too cold and dark when I get home from work to mess with it. The other 2 plugs on the front side of the engine turn with a little effort and the spark plug socket is new (well, 4 years old but it’s the first time I’ve used it). I’m going to...

They’ve been changed. All services have been done on time and done by Toyota…… well atleast all the services have been paid for at Toyota…. Wether or not they did the work I can’t say

He got $300 scrap price for it. He’s been driving my Jeep to work while he saves for his own car since my brother gave me his Camry (long long story, 347,000 miles and has only been serviced by Toyota)

My GF’s truck is up and running again. For whatever reason GM put the caliper bracket bolts in with red loctite. I couldn’t even budge it with heat and there is no room to get a socket and impact on the top bolt without taking the upper control arm out. I finally had to cut the bolt heads with a...

How do you know if you have a broken spark plug without disturbing the spark plug? my Camry has a random misfire on cylinder number 6. I moved the coil to another cylinder and it still have a random misfire on cylinder number 6. when I attempted to remove the spark plug from cylinder number 6...

No…. No it wouldn’t…. Oh you might kill the body, but the AI will upload itself to the cloud and just find another body

Dude… I was drooling on the bad boy Zero turn mowers when I bought my Toro yesterday…. Man I wish I could afford them. I think I’m just going to Kubota diesel repower my Husqvarna rider when the Kawasaki dies.

The M-139 ramps on US 31 bypass are closed so all that traffic is getting off the bypass and rolling straight through Berrien Springs…. Even the trucks. It took me 15 minutes to drop my girlfriend off at work on my way out of town this afternoon.