• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Search results

  1. 2.8 distributor install question.

    I’m going to be installing my distributor back in after I rebuilt it. I’m on #1 TDC (compression stroke). Marks on the balancer are lined up. Looking at the manual for the truck the number 1 position on the distributor is not going to have the rotor pointing to the number 1 piston. I’ve always...
  2. 2.3 transmission recommendations

    Does anyone know if the cranks are the same for a 2.3 na and 2.3 turbo?
  3. 2.3 transmission recommendations

    I do a lot of electrical and wiring repairs at the shop I work at, you’re definitely right. A lot can get thrown off.
  4. 2.3 transmission recommendations

    The goal is to mount it in the original location behind the passenger side kick panel. I’ll probably have to extend the harness but that seems to be the best place for it.
  5. 2.3 transmission recommendations

    I’ll be using the electronics and ecm from the 97
  6. 2.3 transmission recommendations

    Thanks for all the replies, definitely given me some direction.
  7. 2.3 transmission recommendations

    I’ve got an 85 ranger. It’s got the 2.8 v6 5 speed 4x4. I’ve gotten tired of trying to find parts for the 2.8 so I bought a 2.3l from a 97 ranger that I’m going to swap. Does anyone know what transmission would work well with this configuration? I’m wanting to stay with a 5 speed and have my...
  8. 85 ranger help

    Thank you, I will give them a try.
  9. 85 ranger help

    I’m needing a part number for a distributor drive gear. It is the 30-2691 for the conversion.
  10. Ignition connector help.

    Do you know what this would be?
  11. Ignition connector help.

    Thank you! I’ve been racking my brain about this one. I did notice the discoloration like it wasn’t plugged in but according to the wiring diagram the blue and red wire was ignition so I figured I was just missing something. Thanks for the help!
  12. Ignition connector help.

    I have an 85 ford ranger 2.8. I removed the engine harness to make a lot of wiring repairs. I have connector that I cannot find where it goes. I took a lot of pictures before I removed harness but I can’t find this particular one anywhere.
  13. Clutch switch

    Thank you I appreciate it!
  14. Clutch switch

    Do you by chance have a part number, I can’t seem to find it anywhere.
  15. Clutch switch

    I couldn’t find one either but on the wiring diagram for it it shows to have one.
  16. Clutch switch

    Thank you, I will look in to it.
  17. Clutch switch

    I have an 85 ford ranger and I’m trying to find the clutch switch and part number for it. Also will this have a clutch switch and neutral safety switch.?

Sponsored Ad


Sponsored Ad

Top