Search results

Can I get the front drivers side seat bracket/rail?

Can I buy the drivers side seat bracket/rails. It can be a little rusted. Just need solid metal on it. Thanks

Thanks for checking out my pages. Yea I'm a master fabricator by trade title. I could make some brackets with sliding rails, but it comes down to a time issue for me. I would 100% rather buy some stock brackets/rails than try to find time to make some.

Thank you all. I just welded in a new floor so I will have to drill in new bolt holes for the rails.

Need some seat rails from a 80's Ranger or BII or bronco. Or whatever else will work for my 88 Ranger standard cab.

I am asking here to see if someone happens to have one as well. Since there is a wanted section on the forums.

No I need door cards aka interior door panels.

Looking for a 7 foot bed single cab from off of a 1st gen Ranger around the New England Area. YES I know about car-parts.com if you don't have a bed please re-frame from replying. Thank you.

I need used door cards for a 1988 Ranger, no power windows. I have blue, but I don't care what colour you have, thanks

Dang, I'm at the point where I'm willing just fork out the money for it. If I can get the correct parts in my hand, I can send them down to my old high school machine shop and see if some of the students there can make me a few spares as a school project. I desperately need a safe tight steering...

I've gotten two columns off of there and they where both junk. I want new parts to rebuild mines instead of picking up another 40 year old column that will need to be rebuilt in due time.

Do you know which bearing to pick up from this list on mcmaster?

Thank you so much guys!! This is a awesome start. I've been trying so hard to find the proper bearings and bushings, etc. This is the information that I needed. If anyone else knows of any other parts that I may need to rebuild the steering column please feel free to post up. This will also make...

please let me know if you happen to find that thread. I looked around and couldn't find it.

I need a REAR driveshaft for a 1988, single cab, 5pd, seven foot bed Ranger. The length of the driveshaft is 51.25"

Thanks, I've looked through amazon andd haven't found much either. I'm still stuck in the same spot as before. Where I get a lot of vague information but nothing solid to go off of. Not even a part number or a couple of universal ones that may work with some fabin' and welding, etc.

Thank you, do you happen to know which ones would work though? I have surfed through jegs and summit and the catalog for aftermarket steering columns is a mile long. I do not even know where to start or which one would fit.

Hi folks, I made a post about this many years ago but didn't get many replies. At the time I was looking for anyone that knew if the bearings in the steering column where available anywhere or ways that a person could make their steering column tight. Or suggestions on any suppliers that sell an...

Does it have dana 28 axles?

Is the floor solid enough around the driver side seat to cut some sheet metal out for me? I can send you a picture of the section that I need.