Search results

I need used door cards for a 1988 Ranger, no power windows. I have blue, but I don't care what colour you have, thanks

Dang, I'm at the point where I'm willing just fork out the money for it. If I can get the correct parts in my hand, I can send them down to my old high school machine shop and see if some of the students there can make me a few spares as a school project. I desperately need a safe tight steering...

I've gotten two columns off of there and they where both junk. I want new parts to rebuild mines instead of picking up another 40 year old column that will need to be rebuilt in due time.

Do you know which bearing to pick up from this list on mcmaster?

Thank you so much guys!! This is a awesome start. I've been trying so hard to find the proper bearings and bushings, etc. This is the information that I needed. If anyone else knows of any other parts that I may need to rebuild the steering column please feel free to post up. This will also make...

please let me know if you happen to find that thread. I looked around and couldn't find it.

I need a REAR driveshaft for a 1988, single cab, 5pd, seven foot bed Ranger. The length of the driveshaft is 51.25"

Thanks, I've looked through amazon andd haven't found much either. I'm still stuck in the same spot as before. Where I get a lot of vague information but nothing solid to go off of. Not even a part number or a couple of universal ones that may work with some fabin' and welding, etc.

Thank you, do you happen to know which ones would work though? I have surfed through jegs and summit and the catalog for aftermarket steering columns is a mile long. I do not even know where to start or which one would fit.

Hi folks, I made a post about this many years ago but didn't get many replies. At the time I was looking for anyone that knew if the bearings in the steering column where available anywhere or ways that a person could make their steering column tight. Or suggestions on any suppliers that sell an...

Does it have dana 28 axles?

Is the floor solid enough around the driver side seat to cut some sheet metal out for me? I can send you a picture of the section that I need.

Dang, everyone's is torn lol. I want the stock one. Thanks for the quick reply though.

Can I get the coolant res cap? I know it's a silly request but mines fell off. Shoot me a pm if you're willing to ship it. Thanks.

I'm in for some of your parts. I'm finally taking my truck off of the road to rebuild it. Will you sell parts or is it all or nothing? Also shipping to MA 01129? Thank you. I'll shoot you a pm as well too.

Def in the market, I was looking for some to no avail.

Thank you so much, really I have been hunting these parts down for awhile.

I checked LMC they don't have it. they have the door skin patch and the floor pan, I do not need those. I need the rear floor section and the front "U" rocker panel door jam section that no one sells. :(

I need the sheet metal that is under the driver seat, and the curved front part in the door jam (rocker panel) for both sides.

If you're willing to cut some pieces of sheet metal off of that cab please, please let me know. Thanks.