Search results

I think something like this would fit Take a look at this link here. I think, something like this is what i understood you meant. With the toolbox placed that way, it'd be easier to make the shell fit the way probably, you suggested...

Thanks so much. I'm considering the toolbox thing, since i fix vehicles.

Hi people! Got a shell off a ranger at a junkyard sometimes ago. But discovered, the dimensions of the shell, seems to be different slightly with my '95 ranger bed. Below in the pictures attached are two ways i have temporarily installed the shell cover, inorder to modify it to fit my bed...

Los, Nigeria

Mehn, unfortunately, I'm in Lagos. Hot rodding isn't just common over here.

After doing the floor plate thingy, would the steering shifter positioned at the steering wheel, be left like that?

Another problem i think i may encouter is, how does one modify the transmission shift to fit a ranger? On the 1UZ, and other Asian vehicles, the shift level position is not at the steering location, but floor. Asian vehicles that have had their shift level at the exact points where ford has had...

Just curious here. Won't the sits from a '95 or so, 4.6l limousine fit? It's leather, and somehow comfortable. i nearly wanted to get those for my ranger '94, but wasn't sure it'd fit.

Mehn, love this truck

Took measurements, and discovered it's a six foot bed.

You care to explain what a toe is? Where are these toes exactly located?

Yes, it's of the clamps, and got it from a junkyard truck.

If i decided to install my clamps this way, wouldn't it be difficult for the bed liner to be reinstated?

This is what i needed. How to clamp, and position those clamps. Thanks so much sir

Yeah, I'd have preferred the plastic one too, but it's just damm hard getting new parts, especially the tank.

A. Camper shell installation and size? I got a camper shell some months ago, which i intend to install on my ,'95 ranger truck. Got few issues, requesting for your helps: 1. I have got a camper shell, from one of the ranger trucks, similar to mine, from a junkyard. But the truck i got it off...

How does one know a truck bed is a 6/7 foot one? I got a '95 truck ranger single cab, that i have been looking for how to install the camper shell

Treated the rust under the truck bed; replaced the fuel pump and tank.

That's the plastic retainer clip I'm referring to. Is there a trick in how it should be installed? There also isn't much rust on the frames, but I'd have to treat them for future remedies. I may even lift the truck too. I can only see the leafsprings are just 3 on each sides. I may add two...

I was able to remove the truck bed yesterday. It wasn't that difficult. The problem i have now is how do i key in the plastic retainers holding the fuel hoses on the fuel pump back? One of the clips were broken, while the other was intact. Is there a trick or tool used to remove remove or fix...