• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Search results


  1. dmb2613

    1999 ranger 4.0 auto

    I picked up my truck Friday, had a tranny put in it. Works like a new one, with a life time warranty including parts and labor. Well lo and behold the heater stopped heating. Had a new thermostat installed when the tranny was put in. One hose hot and the other cold , flushed the core no love...
  2. dmb2613

    What did you do to your Ranger today? (Part Deux!)

    I dropped my 1999 4.0 narrow bed off at the shop to get a new tranny put in it, have had no reverse for a few months no lol
  3. dmb2613

    98 4.0 ???'s

    If it was in VA, it would be in my yard by now if your info is correct
  4. dmb2613

    1998 3.0 high idle when clutch is pushed in UPDATE

    I got a Motorcraft one today and all is well. the aftermarket ones dont work for me
  5. dmb2613

    1998 3.0 high idle when clutch is pushed in UPDATE

    Yes, but I hooked it back up this morning
  6. dmb2613

    Brake lights stay on

    Adjust the switch closer to the pedal
  7. dmb2613

    1998 3.0 high idle when clutch is pushed in UPDATE

    idles around 500 rpm
  8. dmb2613

    1998 3.0 high idle when clutch is pushed in UPDATE

    today I unplugged the IAC valve and no more fast idle, works fine so there is a problem with the signal coming to the IAC vale , thoughts please
  9. dmb2613

    1998 3.0 high idle when clutch is pushed in UPDATE

    cant find any vacuum leaks, it will come back down to an idle , about 700 rpms when I stop, idles fine until I drive it, does not go to very fast idle [3000 rpms] all the time.
  10. dmb2613

    1998 3.0 high idle when clutch is pushed in UPDATE

    It is worse when it is cold , engine reves to 3000 at stop sign [ manual trans] it will come back down but takes a minute or two. I installed a new IAC valve same thing. Thoughts please Thanks David
  11. dmb2613

    Which Drums should I buy

    Rock auto will save you some cash 2004 FORD RANGER 3.0L V6 Drum | RockAuto
  12. dmb2613

    98 B3000 clutch

    no air in the system, and the firewall is not flexing either.
  13. dmb2613

    98 B3000 clutch

    hey guys my clutch has to be almost pushed to the floor to get it into gear. is this normal for a new clutch it releases about 2 inches from the floor Thanks David
  14. dmb2613

    7.5 vs 8.8

    nope on the torque but you will have a bit larger brakes
  15. dmb2613

    What did you do to your Ranger today? (Part Deux!)

    I replaced the wiper transmissions in my 1998 B300. Was a piece of cake until I dropped the bolt that holds the transmission arm to the wiper motor. Took an hour to find it lol
  16. dmb2613

    Manual transmission hard to shift when engine is on

    clutch/hydraulic problem when does the clutch start engaging when letting the peddle out?
  17. dmb2613

    Idler pulley from Rock Auto

    I have an idler pulley that I bought from rockauto, it is for a 1998 3.0 It says It will not work with the original bolt and spacer . Where can I get the correct one?
  18. dmb2613

    David in VA

    Yes that is my favorite one 4.0 auto, waiting on a transmission no reverse in it now. 1999 model
  19. dmb2613

    1996 4 cyl. 2.3 2wd ac issue

    Drain and draw a vacuum on it and recharge with the correct amount of Freon
  20. dmb2613

    1993 ranger 3.0 auto 2 w dr bad transmission no reverse

    I was fearful of that


Top