You probably have VCP pipe, I would recommend going with sch 40 pipe it will stand up better than sdr 35 plastic pipe. Also going around your building may not work depending on how much fall there is from the house to property line. The standard fall for sewer pipe is 1/4 inch per foot to the...
I just took the seats out of my 98 and installed them into my 93 bolted up just fine but had to change out the seat belt parts on the seat. Do to the newer style buckle setup, no biggie. You are thinking why did I do that, dang tree fell on my 98s cab darn the luck.
last fall I bought a 93 Ranger for $2000. It has 4wd a paint matching topper and very little rust, and I named it Barney because he is purple. I think you should try to talk him down because of the rust. I do like the explorer seats and the interior is fantastic.
starting to remove the timing cover on my 2000 ranger leaking antifreeze , did the same thing to my 98 which was running great till we had a wind storm a few years back and a tree fell on it, and totaled it out with only 100,000 on it. didn't have a scratch till then, darn the luck.
I went to a web site FordF150.net that showed that exact part and how to disassemble it and put it back together took him 6 hours. I typed in Ignition cylinder actuator rod for 99 ford ranger and that is what popped up might check that out.
we run Bobcats and build rock walls, if we ran a thin cutting edge we would break the center of the bucket out. we also do a lot of prying out stumps,, asphalt, concrete. so I would go for a better cutting edge, just saying.