• Welcome Visitor! Please take a few seconds and Register for our forum. Even if you don't want to post, you can still 'Like' and react to posts.

Search results


  1. EGR Manifold Thread Size/Pitch

    The insulation on my EGR tube was falling apart, so I planned to pull it and put some heat wrap on it since I had plug wires real close to it. When I went to take the lower part off, I noticed the tube was rusting pretty badly, so I just ordered a whole new tube. Was cheap enough. I had...
  2. Bed/Body Rust Protection

    Wondering what is the most effective and best way to protect my truck body, rockers, truck bed in general, pretty much any sheet metal on the truck from rust. I got the frame taken care of. No rust in the fenderwells or rockers at the moment. There is some rust present underneath the bed, but...
  3. Towing Capacity Question

    I plan to tow a rental tow-behind boom lift soon. It's weight is 4,800 pounds. Truck specs is 2002 Ranger XLT 4x4 4.0L 5 speed auto 4.10 LSD. I have a Class III hitch, trailer brake controller, and all the wiring going from the controller to the plug in the rear from the previous owner. I'm...
  4. Vibration in Seat and Pedals

    Do not know if this is the correct forums for this post. So I have a vibration in my seat/pedals from about 65-70'ish. I've done the following to try and fix it with none of it working: Had someone balance them, still vibration. Won't matter in the next test I did Jacked up the rear and drove at...
  5. Strange Dash Noise

    I have a strange dash noise. I haven't been able to record it. The only way I can describe it is as if there's a mouse inside the dash scratching real quickly. I obviously don't have a mouse in my truck. It's not consistent. It used to be only when the AC ran. Now it'll start doing it like 2...


Top