86isuzu
TRS Member Since 2003
Supporting Member
Firefighter
EMT / Paramedic
ASE Certified Tech
TRS Banner 2010-2011
TRS 20th Anniversary
Ham Radio Operator
GMRS Radio License
- Joined
- Aug 7, 2007
- Messages
- 453
- Reaction score
- 9
- Points
- 18
- Location
- Eden, NY
- Vehicle Year
- 1989
- Make / Model
- Ford Bronco II
- Engine Type
- 2.9 V6
- Engine Size
- 2.9L
- Transmission
- Manual
- 2WD / 4WD
- 4WD
- Total Lift
- 2"
- Tire Size
- 31"
Hey ya'll. Mods, feel free to move this to a different forum if this isn't correct.
1989 Bronco II 2.9L
Was replacing my brake lines when I happened to break one of the fuel connectors at the fuel filter. So I did not relieve the pressure the correct way. Swapped the filter out, put a new end on the line, and checked the inertia switch (it shows red). Turn the engine to "on" and can't here the fuel pump kick on. Was running perfectly fine beforehand.
Any ideas?
1989 Bronco II 2.9L
Was replacing my brake lines when I happened to break one of the fuel connectors at the fuel filter. So I did not relieve the pressure the correct way. Swapped the filter out, put a new end on the line, and checked the inertia switch (it shows red). Turn the engine to "on" and can't here the fuel pump kick on. Was running perfectly fine beforehand.
Any ideas?