- Joined
- Aug 15, 2019
- Messages
- 4,005
- Reaction score
- 1,986
- Points
- 113
- Location
- Oklahoma
- Vehicle Year
- 1993
- Make / Model
- Ford Ranger
- Engine Type
- 4.0 V6
- Transmission
- Manual
- 2WD / 4WD
- 4WD
You might find a swap best. IF you can find a suitable swap in your situation. With limited skills/tools/transportation, and knowledge of the job, it could be tough. A pick N pay junkyard would be the place to look, but as stated, even that is not easy on a newbie, or maybe it is, depends what you run into there. You could also search the marketplace listings for similar trucks, Transmissions, for possibilities.So does it matter the type of welder you use?I tried with my friends lincoln electric I think MIG welder,the kind where you pull a trigger and wire feeds through and makes lots of sparks?If that should work then I'm betting I need to improve my welding skills,but that seemed to fail quicker than any of the jb weld options,and thank you for the answer
Unless you just stumbled across a loose bell housing laying around somewhere a complete transmission swap might work best. Good luck with it man