Thanks for all the replies everyone! The first mistake I made was not watching the video first, the face doesn't have to come off to replace the odo drive gear. I put a solus on it and the speedo is exactly 10 MPH over the speed sensor pid, so 80 is the new 70. I had to JB weld every clip back...
I replaced the trip odometer worm gear, had to pull the speedo needle off to gain access to the gear drive. now the speedo reads fast, about 10 mph. Is there anything I can do to re calibrate it?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.