Used fluid film inside the crossmembers.Yes if they were available i wouldve bought them.
It was a very kool project,and i drive it everyday.
I Always liked the 4cyl,5spd,2wd longbeds.Thanks bud
its got some rust issues,hasnt been registered since 2014. Its a yard truck.Plows very good.
Frame is good.the body needs some work.
In the future I may figure out how to either put a cap back on it,or build a better wall/divider and keep it like a pickup.
Been trying to get some ideas on what...
Cost was
3-crossmembers $120
1-sheet of 16g.steel $48
3-bags of bellemare 30-60 glass grit $34
misc grinding discs etc $30
Paint-will paint along with the truck frame at a later date.
Used a lincoln 140c welder {im not an expert}and a clarke 10 gallon blaster in my home garage.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.