Recent content by mkyhmltn

Looking for a set of hubs for my Bronco II, Stock D28. Located in southern CO

Im in Colorado Springs

If it is doing it in every gear except 4th it sounds like the pocket bearing is bad.

One of my guys just got one. It is a nice truck, but not the price.

Looking for a center console if you have one. Prefer red, but can work with any color.

Got rid of my ranger a couple years ago and just been doing other things. Picked up an 89 Bronco II yesterday, good solid body decent interior, good running 2.3 and 5 speed, yes It has a 4 cylinder. Previous owner had a wrecked ranger with a good engine and a bad engine in the bronco. Has a few...

Will get some up in the next day or two.

I did a shackle flip on the rear.

Just coils, dont know anything about them as I got them used and the PO was unsure as to what they were exactly.

I wish it was that easy. It would end up way to low if I did that. First lowered truck I've ever had, always lifted before.

So I put some 2 inch drop coils in my 92 ranger and now its sitting on the bump stops. Is this normal?

Ok, I have been thru the tech section about what seats will fit and my pick n pull here has a bunch of mustangs, but not much for anything else on the list of seats that bolt right up. My question is, is there any specific years of Mustang seats that fit or are they all pretty much the same? The...

Thought about cutting them, just not something I like to do. Maybe I will just say the heck with it and get the 2 in springs.

I just did the shackle hanger flip on the rear of my 92 ranger and was wanting to go about 1 inch lower in the front. All I can find is 2 inch and up for springs or beams. Anybody know of a source for 1 inch drop springs?

I have a 92 ranger that I am looking for wheel studs for, problem is that I need longer than stock. Anybody know where to find these? I have already tried all the places that I can think of.