My problem is im not sure which will be better for what im going to do my truck is a 1991 regular cab short bed 2wd I have a:
rebuild 5.0
efi out of a 5.0 ho mustang
a holset hx35 turbo
its only going to see 6-8 lbs of boost
t-5 or
c4
i have almost everything to go either way but im not sure...
HI I just bought a 1999 ranger ex cab 3.0 2wd auto. the truck was parked a year or so ago because it quit running it has ben sold twice since then but nobody bothered to fix it. the truck will not crank it will turn over but it acts like the starter is draging. it does have fire and i have put...
I'm considering building a twin turbo 5.0 for a ranger I'm just wanting some feedback from those who know something about turbos. my questions are
What horse power should i expect with twin t3/t4s on a roller 5.0 EFI rebuilt with forged pistons?
whats the best options for fuel/ignition...
Hi i have a 1991 2wd regular cab ranger with a 2.3 and a auto trans. The truck is all stock with around 140,000 miles. I checked my mileage the other day and was very disappointed to find that i was only getting 16mpg this seams low being that both my other rangers get 20-25mpg with a 4.0 and a...
I have a 1992 ford ranger 4x4 with a 4.0 and an automatic transmission. It has an 8.8 rear end. I have replaced the axle seals on the back right twice and its still leaking . The bering is good and the shaft doesn't have any wear on it. There is no play in the bering and the vent line for the...
Will the air box from a 1993 explorer with a 4.0 work in a 1992 ranger with the 4.0 i just need to know if they are the same because the tabs are broke off my air box on my 1992.
thanks.
would a three speed manual transmission out of a 70ish truck be worth using for a 302 swap in a ranger or is it kinda a waist of time to use a three speed...thanks
i know this subject has came up before(i searched) but no real answers were given. so my question is would a 390 be a good swap choice for a 2wd ranger i know they are heavy but can you make good hp and torque with it...also would a dual sump oil pan be required to make it work...and how would...
I have a 1985 ranger two wheel drive short bed with a 2.0. I want to put a v8 in it but i want to know what is the most important factor when it comes to moving a ranger down the track/road with a v8.... Horsepower Torque or Traction or what combination of the three:3gears...
what would a 1987 bronco 2 weigh.
i am looking at one and the guy said he would sell it for $12.00 a hundred
it has a 4 inch skyjacker lift and a 3 inch body lift the engine is good but the auto transmission is shot (only reverse works)
what do u think?:icon_confused:
what would you guys say a running driving 351w with around 15,000 miles on it and a automatic transmission would be worth i think it would be a c6 because it is in a large van....I'm just going for a ball park figure... the guy said he wanted $600 for it but i don't really know what its worth
thanks
hey guys i'm looking at an 1988 bronco ll xlt. it had a 2.9 but it was removed for use in another Bll. But still has everything else. the windshield is cracked the body has dents and the front fenders are bent up a little and the fiberglass in the rear hatch is cracked. but it is a 4x4 all...
hey guys i was wondering if there were any differences between a two wheel drive b2 frame and a four wheel drive b2 frame. also would a d35 bolt into a two wheel drive b2 frame without modification?
thanks
this a typical "how much is it worth" question it is a 1987 Honda crx dx with 124000 miles on it. I know it has a bad head gasket and has ben sitting for the last three years. i could get it for 300. is that a decent price?
i need to see the pictures where a t5 world class 5 speed was converted to use a hydraulic clutch from a 280zx but i cant find that thread again any other information on the subject of converting a manual clutch to hydraulic would be helpful.
thanks:icon_hornsup:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.