If memory serves me right 5.0 fox body dual sump pan thats whats on my 2wd 88 dont know if 4x4 is different. dont have a part number but im sure rock auto will have one
that is a good deal I'm about that into mine and its no where near done yet but seeing that add made me think of an old thread I read years ago before I joined the forum cool find
https://www.therangerstation.com/forums/index.php?threads/4-6-swap-tutorial.139482/
sounds like a solid plan only things i can advise are do the rear main seal well its out and take the clutch fan off that way its not in the way, also less likely to brake it wish you luck I'm looking forward to seeing it
Hi so just went out and measured mine its 8 feet to the chain the leveler was on the 4.6 to help level it a bit when making the custom mounts fit. didn't go into any head bolts honestly don't remember what I hooked on pullet it out of the vic did it on august 1 2021 and put in the ranger October...
I like your engine lift built one like it 3 ish years ago I got a chain off a old tow truck rapped around the top, my come along has a hook so I just take it off when not in use. it's still sitting in front of my garage have pulled 7 engines with it just tighten the lag bolts before every use...
I'm looking at doing this in my 1992 5 speed truck what rear gear ratio are you running and what kind of mpg? i'm mainly going to do highway cruising so about 75 mph ( 120 km) just trying to figure some details out before its to late. Thanks
the tow rope is so the hood stays on in the wind cant get a good pic under the hood with the engine rapped up in a bag but will take one when I get back to the project
it fits i have it on just don't have a pic has about1/2 inch to 1 inch if you take the insulation off haven't cut the support. Im going to put a 82 fox body hood scoop on it don't need to but I like the way they look on theses truck I got one on my 88 ranger with 89 front clip. Ill run out and...
Hi so I posted on a different thread that mentioned a 4.6 the other day and was recommend by a member to start a thread of my build. so here it is I haven't touched it cents spring time its a 1991 was a 2.9 auto truck the donor car was a 2003 ex under cover cop. I used ford e250 motor mounts...
you guy's aren't wrong its not the best choice but i did it in a 91 extended cab i used a 03 crown vic drive train its still a work in progress got it to run i have a video of it running its not pretty no exhaust manifolds but it fits not bad even clears the hood. i used e250 motor mounts and...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.