Clay46
New Member
- Joined
- Sep 16, 2016
- Messages
- 20
- Reaction score
- 0
- Points
- 1
- Location
- Birdsboro,PA
- Vehicle Year
- 1987
- Make / Model
- Ford
- Engine Type
- 2.9 V6
- Engine Size
- 2.9
- Transmission
- Automatic
So I got into a situation where I need to build my parts truck into my daily and one part I need is to figure out the driveshaft, I pulled engine and trans from a single cab 87 and put it into the extended cab parts truck which is also an 87. I found a usable driveshaft in a junkyard but it didnt have the end that goes into the trans. So what I have found is that the single carbs and extended cabs use different size u joints. Both 2wd if it matters. I have looked all through the junkyard for the end that goes into the trans from an extended cab but all the manual extended cabs dont have driveshafts. So my last resort here is trying to find a conversion u joint which seems pretty stuff to find. I have found that the single cab uses a spicer 1310 and the extended cab uses a 1210 but cant find the u joint, any help at solving this issue would be appreciated, I've been searching for weeks