-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
84 2.8
- Thread starter Bronco
- Start date
- Joined
- Aug 6, 2007
- Messages
- 3,843
- Reaction score
- 1,682
- Points
- 113
- Location
- Macon/Fort Valley, GA
- Vehicle Year
- 1999
- Make / Model
- Ford
- Engine Type
- V8
- Transmission
- Automatic
- 2WD / 4WD
- 4WD
I'd say post this in the exhaust forum. OTOH if I were to give an answer I'd probably say 2 1/4" to 2 1/2" aught to be plenty, and possibly to much.
84Ranger4X4
New Member
- Joined
- Nov 11, 2007
- Messages
- 59
- Reaction score
- 1
- Points
- 0
- Location
- Vacaville, CA
- Vehicle Year
- 1984 and 1987
- Make / Model
- Ford
- Engine Size
- 2.8 and 2.3
- Transmission
- Manual
Either 2 1/4 or 2 1/2. I have 2 1/2 on mine with a 40 series Flowmaster.
85_Ranger4x4
Forum Staff Member
TRS Event Staff
TRS Forum Moderator
Article Contributor
V8 Engine Swap
OTOTM Winner
TRS 20th Anniversary
VAGABOND
TRS Event Participant
- Joined
- Aug 7, 2007
- Messages
- 32,318
- Reaction score
- 17,774
- Points
- 113
- Location
- SW Iowa
- Vehicle Year
- 1985
- Make / Model
- Ford
- Engine Type
- V8
- Engine Size
- 5.0
- Transmission
- Manual
http://www.magnaflow.com/07techtips/faq/question10.asp
This seems like a pretty good rule of thumb. But then I just put a 2.5" on mine, just because it is the old exhaust off of my brothers truck and it was free. I really haven't got to drive it much but it is really quiet, I have the complete exhaust off of a 1997 F-150 with a 4.6, stock muffler and all.
This seems like a pretty good rule of thumb. But then I just put a 2.5" on mine, just because it is the old exhaust off of my brothers truck and it was free. I really haven't got to drive it much but it is really quiet, I have the complete exhaust off of a 1997 F-150 with a 4.6, stock muffler and all.
Original_Ranger84
Active Member
- Joined
- Aug 23, 2007
- Messages
- 4,690
- Reaction score
- 20
- Points
- 38
- Vehicle Year
- 1984, 1999
- Make / Model
- Ford
- Engine Size
- 2.8L, 3.0L
- Transmission
- Manual
I have no cat and ran 2 1/4" pipe to a Flowmaster 40 series and y piped it to dual exhaust coming out behind each rear tire. (about stock but 2x better)
Sponsored Ad
Sponsored Ad
Staff online
-
85_Ranger4x4Forum Staff Member
Today's birthdays
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Truck of The Month
Shran
April Truck of The Month
Recently Featured
Follow TRS On Instagram
TRS Events
25th Anniversary Sponsors
Check Out The TRS Store
Sponsored Ad
Sponsored Ad
Sponsored Ad
Amazon Deals
