85_Ranger4x4
Forum Staff Member
TRS Event Staff
TRS Forum Moderator
Article Contributor
V8 Engine Swap
OTOTM Winner
TRS Banner 2010-2011
TRS 20th Anniversary
VAGABOND
TRS Event Participant
- Joined
- Aug 7, 2007
- Messages
- 32,218
- Reaction score
- 17,533
- Points
- 113
- Location
- SW Iowa
- Vehicle Year
- 1985
- Make / Model
- Ford
- Engine Type
- V8
- Engine Size
- 5.0
- Transmission
- Manual
Right now there is a black second gen in the 60th street U-Pull it that has a lot of do-dad's on it.
Billet grille.
Clear front lights (one reflector is busted though)
Aluminum front skid plate.
Roughly 4" lift kit in the front, I am not real up on what lifts look like but there is a Rough Country decal on the front skid plate. It looks like a factory made kit of some sort though.
2" blocks in the back, with the stock block and stock looking springs. Going to guess it was intended to be leveled.
Square tube pre-runner type front bumper/grille guard that looks pretty good for a homemade creation. It has the hoop that leans ahead with light mounts.
2" body lift.
Square tube ladder style rear bumper that fits up between the tailgate and rear fenders like a roll pan. Again looks pretty good but does have a bunch of holes in it from whatever the square tubes original purpose was.
Looks like standard issue D35 and 28 spline 8.8, there is also a Yukon Gear sticker on the skid plate so who knows what goodies are inside though.
Billet grille.
Clear front lights (one reflector is busted though)
Aluminum front skid plate.
Roughly 4" lift kit in the front, I am not real up on what lifts look like but there is a Rough Country decal on the front skid plate. It looks like a factory made kit of some sort though.
2" blocks in the back, with the stock block and stock looking springs. Going to guess it was intended to be leveled.
Square tube pre-runner type front bumper/grille guard that looks pretty good for a homemade creation. It has the hoop that leans ahead with light mounts.
2" body lift.
Square tube ladder style rear bumper that fits up between the tailgate and rear fenders like a roll pan. Again looks pretty good but does have a bunch of holes in it from whatever the square tubes original purpose was.
Looks like standard issue D35 and 28 spline 8.8, there is also a Yukon Gear sticker on the skid plate so who knows what goodies are inside though.
Last edited: