Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
Ran fine and when I went to start it today it had no fire. Coil??
I did use the stock coil, got another one like it from a ford guy down the road and tried it with no success. I'm not sure how the power supply runs through the ignition system but I may just start at the switch and go through it. I never did remove all the harness from the computer through the fire wall, should probably eliminate all the wires not needed first. How do you get to the computer?
Converted it about 6 months ago but have driven it very little. Been battling oil and transmission leaks mostly. Drove it one day, jacked it up, put in a new trans filter and gasket, let it down and it wouldn't fire. Checked for fire with a spark plug in the coil wire, had my wife crank the engine, got one spark twice when she hit the key and that was it. No spark since.
Thank you Shran and thank you Pete. I did use the Duraspark box. Busy evening ahead but will look up how to check the distributor later tonight.
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
