l0sts0ul
New Member
- Joined
- Jul 15, 2014
- Messages
- 50
- Reaction score
- 0
- Points
- 0
- Location
- Edmonton, AB, Canada
- Vehicle Year
- 1994
- Make / Model
- Ford
- Engine Size
- 3.0L
- Transmission
- Automatic
Hey Guys,
OK, heres the problem, and I've scoured the interwebs to find a solution, and non one seems to be able to give me a straight answer
I have installed a v8 into my 94 ranger.
the tranny is a C4, bellhousing stamp code is D9AP-7976-AA.... after review, I know this is a 157tooth bellhousing. There fore, I purchased a 157tooth flexplate (28oz), with a block plate to fit.
I tried to start this thing finally tonight, however the starter gear just spins. I installed a CVR starter (3.5hp), but I can't figure out the problem.
Im worried that i can go grab a torque for my flex plate, and setup, but im screwed if it doesn't fit, because I can't return them. I am sitting on a 164 tooth flex plate, so just a torque, and block plate would work.
Need help asap, as im dying to start and run this thing.
thanks again
OK, heres the problem, and I've scoured the interwebs to find a solution, and non one seems to be able to give me a straight answer
I have installed a v8 into my 94 ranger.
the tranny is a C4, bellhousing stamp code is D9AP-7976-AA.... after review, I know this is a 157tooth bellhousing. There fore, I purchased a 157tooth flexplate (28oz), with a block plate to fit.
I tried to start this thing finally tonight, however the starter gear just spins. I installed a CVR starter (3.5hp), but I can't figure out the problem.
Im worried that i can go grab a torque for my flex plate, and setup, but im screwed if it doesn't fit, because I can't return them. I am sitting on a 164 tooth flex plate, so just a torque, and block plate would work.
Need help asap, as im dying to start and run this thing.
thanks again