- Joined
- Dec 3, 2016
- Messages
- 221
- Reaction score
- 26
- Points
- 28
- Location
- riverview, fl
- Vehicle Year
- 1988
- Make / Model
- ranger xlt
- Engine Type
- 2.9 V6
- Engine Size
- , 2.9
- Transmission
- Automatic
- 2WD / 4WD
- 2WD
- Total Lift
- none but it is a convertible
- Tire Size
- stock
have the i beams out of the 96 to go in the 88 2wd ranger. the old pivot bushing had about a quarter inch showing on one side and a quarter inch plus the shoulder or head on the other.
should the new bushing be split the same way or is it supposed to go in until the head hits the beam?
should the new bushing be split the same way or is it supposed to go in until the head hits the beam?