myers94
New Member
- Joined
- Feb 3, 2017
- Messages
- 10
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 1994
- Make / Model
- FORD
- Transmission
- Manual
Hey if anyone has any insight on this issue that would be great as I have not found a thread on this specific issue, I am doing a 302 swap in my ext cab ranger and I want to put the m5od-r2 in keep the 4x4 and use the transfercase from the f150 that I would pull it from, but that's were I am lost.
first off is the driveshaft the same 31 spline as the rear axle, and if so will it fit into the transfer case, and then will it have to be a different length than stock and if so how long would it have to be and how would I obtain said different length shaft
I know this is asking a lot in a single question but any input would be great thx
first off is the driveshaft the same 31 spline as the rear axle, and if so will it fit into the transfer case, and then will it have to be a different length than stock and if so how long would it have to be and how would I obtain said different length shaft
I know this is asking a lot in a single question but any input would be great thx