Anyone have any experience with offroad winch bumpers off of jeeps? Looking for a good winch bumper, but not trying to spend the money to get a custom one made
but jeep bumpers are usually not too bad to fit up with minor mods.
i been thinking of doing a chop to keep the roof intact with the glass to make it removable. i have one a fiend did most of the work on and it is extensive to say the least. its 1/2 cab with bed rails and tail gate and works good but is rotting apart underneath.
Started designing some bumpers, anyone have any advice on a coating? I want something I can spray, the shape of the bumpers are going to make it hard to roll anything on.
Got the ranger tailgate on, does anyone have an suggestions for filling in that upper area above the taillights? I don't want to leave it with that big gap in the body, but I don't want to fill it with gallons of bondo either
For
a small yearly donation, you can support this forum and receive a 'Supporting
Member' banner, or become a 'Supporting Vendor' and promote your products here.
Click the banner to find out how.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.