Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
You used the wrong bolts in the opposite spots!
No regrets on the 3", I would do it again in a heartbeat.
no i did not. all the bolts were the same lenghts. they were to long for all the mounts exept the two in the rear, and too short for thoughs two mounts.
I am confused about this. I have done over 20 bl kits with buddies who helped me or I helped them over the years and I have never come across this issue. What kit did you use?? Was it a home made kit you got from somebody or did you buy it?
Crap happens, mixing up two bolts isn't really very hard to do.
A hunk of pipe, a hunk of shaft and a bolt. Weld the pipe to the shaft and drill and tap a hole in the pipe for the bolt to lock it onto the stock lever. With a little paint it looks completely stock with the boot on.How would one make an extension for the 4wd floor shifter? Thanks for all the input guys!
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
