AOMills
Member
- Joined
- Jan 14, 2014
- Messages
- 48
- Reaction score
- 3
- Points
- 8
- Location
- St. George, UT
- Vehicle Year
- 1990
- Make / Model
- Ford
- Engine Size
- 4.0L
- Transmission
- Manual
I'm finishing up a 4.0 swap on my B2 and it's all down to wiring. This ground cable has me stumped, though. I can't get terminal 3 to reach the ground stud on the starter when the cable is bolted to the frame below the airbox. Now I'm questioning if the terminal goes there at all. Can anyone tell me where 1, 2 and 3 are supposed to end up?
Please excuse the crude picture. This is on my phone from the garage.
Please excuse the crude picture. This is on my phone from the garage.