chadsworth2
New Member
- Joined
- Mar 3, 2015
- Messages
- 4
- Reaction score
- 0
- Points
- 0
- Location
- Denver
- Vehicle Year
- 1987
- Make / Model
- Ford
- Engine Size
- 2.9
- Transmission
- Manual
As stated by Jim in the tech articles, when swapping a Dana 28 TTb for a Dana 35 TTb, one must shorten the drive shaft by 1 to 1.5 inches.
Is it possible to use the Drive shaft from the Dana 35 doner vehicle instead of shortening the Dana 28 vehicle drive shaft? Is the Dana 35 vehicle drive shaft the correct length?
Is it possible to use the Drive shaft from the Dana 35 doner vehicle instead of shortening the Dana 28 vehicle drive shaft? Is the Dana 35 vehicle drive shaft the correct length?