Black2000Ranger
New Member
- Joined
- Sep 17, 2010
- Messages
- 45
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 2000
- Make / Model
- Ranger
- Transmission
- Manual
Hello!
I recently changed the engine and transmission in my 2000 ranger and everything runs perfect. The whole time I have had a CEL on but haven't really paid much attention to it as I was just happy to have my truck back.
So just now I decided I would pull the codes and fix whatever the issue was.. Plugged in the code reader..... Nothing. The code reader doesn't even turn on... I didn't swap computers or anything, my thoughts are perhaps a ground issue? Anyone run into this problem before?
Thanks
Scott
I recently changed the engine and transmission in my 2000 ranger and everything runs perfect. The whole time I have had a CEL on but haven't really paid much attention to it as I was just happy to have my truck back.
So just now I decided I would pull the codes and fix whatever the issue was.. Plugged in the code reader..... Nothing. The code reader doesn't even turn on... I didn't swap computers or anything, my thoughts are perhaps a ground issue? Anyone run into this problem before?
Thanks
Scott