Lakota
New Member
- Joined
- Oct 10, 2007
- Messages
- 6
- Reaction score
- 0
- Points
- 0
- Location
- Lorain, OH
- Vehicle Year
- 1994
- Make / Model
- Ford
- Engine Size
- 4.0
- Transmission
- Manual
My RABS light started coming on after I replaced the left rear wheel cylinder. I completely flushed the brake lines to make sure that I go any air out and I cleaned off the rear ABS sensor and this didn't do any good so I replaced it and it is still on.
I need to know what I should look at next either the Hydraulic Control Unit or the Control module. I am leaning toward the control module because looking at the wiring schematics that are in the Haynes manual it shows that Control Module is somehow connected to the Cruise Control and this is also not working. Any help or insight on this would be appreciated. I need to get this done quick because the snow is starting to fly and it is no fun with the rear wheels locking up.
I need to know what I should look at next either the Hydraulic Control Unit or the Control module. I am leaning toward the control module because looking at the wiring schematics that are in the Haynes manual it shows that Control Module is somehow connected to the Cruise Control and this is also not working. Any help or insight on this would be appreciated. I need to get this done quick because the snow is starting to fly and it is no fun with the rear wheels locking up.