- Joined
- May 5, 2010
- Messages
- 1,084
- Reaction score
- 8
- Points
- 38
- Location
- enfield, ct
- Vehicle Year
- 2003
- Make / Model
- Ford
- Engine Size
- 4.0L
- Transmission
- Manual
so in a few weeks i'll finally be installing the amp and speakers i got for christmas. basically a 1400w 4 chan amp with 75w speakers.
for graduation last year my dad bought me a pioneer 3300 but it only has 2 outputs. im going to use splitters to break it into the 4 chan setup. thats all fine an dandy. for now i have a 8" 200w audiovox tube. im going to share the inputs for the tube with inputs for the rear speakers for now to give it a little more kick.
now here's what im wondering. i might be getting a 10" sub to replace the tube. would i be able to split the signal before the amp again and run that to a mono amp or would that cause the signal to weaken too much
like this. (sorry for the crude drawing)
for graduation last year my dad bought me a pioneer 3300 but it only has 2 outputs. im going to use splitters to break it into the 4 chan setup. thats all fine an dandy. for now i have a 8" 200w audiovox tube. im going to share the inputs for the tube with inputs for the rear speakers for now to give it a little more kick.
now here's what im wondering. i might be getting a 10" sub to replace the tube. would i be able to split the signal before the amp again and run that to a mono amp or would that cause the signal to weaken too much
like this. (sorry for the crude drawing)