Terry
Member
- Joined
- Sep 5, 2008
- Messages
- 613
- Reaction score
- 19
- Points
- 18
- Location
- Gardnerville, Nevada
- Vehicle Year
- 1987
- Make / Model
- Ford Ranger
- Engine Size
- 2.9
- Transmission
- Manual
I am putting an 88 tach cluster in my 87 non tach truck. I have gages for amp, coolant temp and oil pressure so I am hooking up the tach and fuel gage. I know that the green stripped wire in pinout # 4 is the signal wire. The black wire with the white stripe in pinout # 3 is comming off the other connector for the tach. I have been looking all over the site and can't find info for where the L2 wire goes. The cluster from the donor truck was a single tank truck and my 87 has dual tanks. It looks like I the yellow wire with the white stripe is for the fuel gage. Any other wires on 1-9 pinout need to be hooked up?