saab900
New Member
- Joined
- Sep 1, 2014
- Messages
- 14
- Reaction score
- 0
- Points
- 0
- Location
- Blacksburg, Virgina
- Engine Size
- 2.3?
- Transmission
- Automatic
Hey all. I've got a 1988 bronco 2 4wd with the fm146. I pulled the trans out to replace the fly wheel and I've got it all back together other than I can not get the front of the drive shaft to fit into the yoke(?) On the front axle (d28?) The bearings won't fit as though it's too wide but I know it fits censuses it came out of there. Any suggestions?