broncofreak
New Member
- Joined
- Oct 7, 2010
- Messages
- 4
- Reaction score
- 0
- Points
- 0
- Transmission
- Automatic
i put a new tank in my 1984 bronco 2 with the 2.8 and now my gauge isnt working i checked the connections and they are fine please help.
-
Welcome Visitor! Please take a few seconds and Register
for our forum. Even if you don't want to post, you can still 'Like' and react to posts.
bronco fuel gauge
- Thread starter broncofreak
- Start date
n_grimm
New Member
- Joined
- Oct 27, 2010
- Messages
- 152
- Reaction score
- 1
- Points
- 0
- Vehicle Year
- 1988
- Make / Model
- Ford
- Engine Size
- 2.9
- Transmission
- Automatic
Have you tried grounding the "hot" wire that goes to the sender to see if the gauge goes up? Also is the ground to sending unit good? Next time I have to pull the sending unit on my B2 I plan to cut an access hole as mentioned on this site so I won't have to pull the tank again.
trail B2
New Member
- Joined
- Jan 17, 2009
- Messages
- 1,289
- Reaction score
- 8
- Points
- 0
- Location
- North Eastern Ca.
- Vehicle Year
- 1986
- Make / Model
- ford
- Engine Size
- 4.0
- Transmission
- Manual
Is it the old sending unit or the one in the new tank.Is it stuck on E and doesn't change? Is the float still on the rod ?The sending unit is the weak link in the system I would start there.
Sponsored Ad
Sponsored Ad
Staff online
-
fastpakrForum Staff Member
Today's birthdays
Member & Vendor Upgrades
For a small yearly donation, you can support this forum and receive a 'Supporting Member' banner, or become a 'Supporting Vendor' and promote your products here. Click the banner to find out how.
Truck of The Month
Shran
April Truck of The Month
Recently Featured
Follow TRS On Instagram
TRS Events
25th Anniversary Sponsors
Check Out The TRS Store
Sponsored Ad
Sponsored Ad
Sponsored Ad
Amazon Deals
