Crowe
New Member
- Joined
- Nov 5, 2016
- Messages
- 5
- Reaction score
- 0
- Points
- 0
- Vehicle Year
- 1990
- Make / Model
- Ford
- Transmission
- Automatic
Hey all. I just replaced the fuel tank, pump and sending unit on my 1990 Bronco ii and can't seem to get it running again. Before replacing the tank and all that I did a full tune-up and replaced the map sensor and tps. I made sure everything was square and the truck was running well before dropping the tank. Although I've replaced tanks and pumps before, this is my first time doing it on a Bronco so I want to make sure I didn't miss something. I've already checked that the pump is turning on, the relay is fine, as is the inertia switch. The only thing I can think of at this point is that maybe I got a bad sending unit. Any insight you can provide would be appreciated.