Welcome Visitor! Please take a few seconds and Xeek
New Member
- Joined
- Mar 11, 2012
- Messages
- 19
- Reaction score
- 0
- Points
- 1
- Location
- virginia beach, va
- Vehicle Year
- 1991
- Make / Model
- ford
- Transmission
- Automatic
Was building a mud.truck with a 302 on propane, kit by gotpropane. At this point i want the 302 in my ranger. I dont.want.that one tho.. its old tired and vbelt. But i have motor mounts and dual sump pan.
I wanted to know if i can do an explorer 302, with the.current intake i have for a carb?
I also have a hei for it, which isnt sitting.right, am i juat not using.enough force to.get it down in.there?
Explorer front dress should.leave me room for.factory radiator placement right? What about mechanical fan?
As far as the , i.can get a 4r70w with the engine, but would i be better off with an aod or getting a stanealone controller?
Trans mount... will it be in the exact location? I have a custom brace built into my arms
Lastly, ill be getting the extra parts needed to.run dual fuel, gas and 10gal propane for.offroading. so should be fun to drive
I wanted to know if i can do an explorer 302, with the.current intake i have for a carb?
I also have a hei for it, which isnt sitting.right, am i juat not using.enough force to.get it down in.there?
Explorer front dress should.leave me room for.factory radiator placement right? What about mechanical fan?
As far as the , i.can get a 4r70w with the engine, but would i be better off with an aod or getting a stanealone controller?
Trans mount... will it be in the exact location? I have a custom brace built into my arms
Lastly, ill be getting the extra parts needed to.run dual fuel, gas and 10gal propane for.offroading. so should be fun to drive
