85_Ranger4x4
Forum Staff Member
TRS Event Staff
TRS Forum Moderator
Article Contributor
V8 Engine Swap
OTOTM Winner
TRS Banner 2010-2011
TRS 20th Anniversary
VAGABOND
TRS Event Participant
- Joined
- Aug 7, 2007
- Messages
- 32,331
- Reaction score
- 17,808
- Points
- 113
- Location
- SW Iowa
- Vehicle Year
- 1985
- Make / Model
- Ford
- Engine Type
- V8
- Engine Size
- 5.0
- Transmission
- Manual
Out of a '84 Bronco with the fixed rear output.
Changing the rear output shaft bearing. The old one had a shield on one side and was retained into the housing by a snap ring in the housing. My new one (SKF 6207-NRJ) has no shield and has a snap ring around the outer race.
Big deal or no big deal?
Changing the rear output shaft bearing. The old one had a shield on one side and was retained into the housing by a snap ring in the housing. My new one (SKF 6207-NRJ) has no shield and has a snap ring around the outer race.
Big deal or no big deal?