MA Ranger
Member
- Joined
- May 19, 2009
- Messages
- 49
- Reaction score
- 0
- Points
- 6
- Vehicle Year
- 1994
- Make / Model
- Ford
- Transmission
- Automatic
The brake warning light on my '94 XLT came on after I replaced the front pads (the fluid was overflowing at the master cylinder after I installed the pads. I siphoned some off and got it back below the MAX line). The two floats inside the master cylinder look normal - not sticking to the bottom and the fluid level is o.k. - about 1/4" below the MAX line. ABS light was on before I replaced the pads. It came on after I had the windshield replaced a while back. I used to get it to go off by unplugging/plugging the ABS module next to the frame rail on the driver's side. Any suggestions would be appreciated.